Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

[QUOTE=Murf;200697] No, no where near those levels, OSHA guidelines call for 5,000 CFM for each propane fueled forklift.That is a little under a 70 foot cube every hour. [/QUOTE] <br>
Kerala Factory rules:<br>
c) " The amount of fresh air supplied by mechanical means of ventilation in an hour shall be equivalent to at least six times the cubic capacity of the workroom and shall be distributed eventually throughout the workroom without dead air pockets or undue draughts caused by high inlet velocities." <br>
<br>
This means 6 ACH for factories. <br>
<br>
5000 CFM,Cubic Feet per Minute per Forklift looks like OSHA has looked at the oxygen consumption of a propane fueled forklift.<br>
<br>
Bazant says that an exercizing person breathes out 3 cubic metre per hour. A forklift therefore consumes 2832 times air than a single person. <br>
<br>
I guess that factory ventilation should be more than 6 ACH.

India first ElectricTractor Sonalika Electric Tiger
Tractor Projects
Replies 13 Post by kvinodkumar

from the E154 thought it is an electric tractor. The typical sound and the vertical exhaust from the combustion say it is not.

Hinomoto E154 charging circuit problems
Hinomoto
Replies 3 Post by kvinodkumar

I guess that N in Cat 1-N does not mean Narrow. Please see a fresh link to picture of the Cat 1-N Three point hitch (Earlier link was not accessible). The width of the tractor is 915 mm. The rear tyres are 6.5 X 16. Does it not mean that the two tyres together are 13 inches wide (or about 320 mm)? So the gap between the rear tyres is about 600 mm or 24 inches. The two black lower hitch connectors are spaced slightly more than 24 inch apart and it nicely matches the 26 inch spec for CAT 1 lower hitch points.<br>
<br>
The Kamco tractor (Tera TRAC 4W) is made in technical collaboration with Barbieri Srl- Italy. I could see Tera TRAC 4A at the Barbieri stable but that has 18 HP. The Kamco belts out 13.4 HP.

Tractor Category 1 2 3 Hitch sizes Defined
Operating and Attachments
Replies 20 Post by kvinodkumar