Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

Thanks guys,think I will pick up some tommorrow as it would seem that this one oil can replace all except 2 stroke for me as well. Simplifies my "stock". It seems to me, by reading the specs, that I should bee able to use this year round. Any thoughts on that?

New JD Plus 50 0W40 Oil
John Deere Tractors
Replies 11 Post by jdgrunt

I agree Mark,
Deere does a very good job with the add-ons. Anyway now I can route the hose further away from the lift arm, and "neaten" it up some too.

Hydraulic Fittings
John Deere Tractors
Replies 7 Post by jdgrunt

testit,
I am biased as I have a 4100 and a F735 as well. I use these commercially and so far had a good experience with my local dealer. What else would you be using this equipment for? I use the blade mostly for slushy stuff and small amounts of snow. The change over is fast and easy. It sounds to me that a blower would be good for you but it is expensive. Sorry about the delay in my response but this is a busy time.

4115 Snowblade
John Deere Tractors
Replies 9 Post by jdgrunt

Mark, sorry about the delay in responding but I finally dug the power trench. As far As I can tell, all the controls work just fine except the stabilizer levers which I found a bit stiff. The only problem I found was a grease nipple on a boom pivot which won't take grease. Everything loosened up some with use. Sure is a sweet toy.

Re Sticky 46 Backhoe Controls
John Deere Tractors
Replies 2 Post by jdgrunt

Mark, sorry for the delay in my response, my controls are a little stiff, but I feel that they need more break in time. Too much pressure is possible but I have less than an hour on the hoe so far. Next week I will be digging in a new electrical service and will see how the controls are then. I will get back to you ASAP.

Factory installed cabs on the John Deere 4010 series
John Deere Tractors
Replies 7 Post by jdgrunt