Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

Make sure all the safety Sws are in the proper position for starting.

Jumpstart tc26da
New Holland Tractors
Replies 4 Post by gotowin

This is A TC33 D. but I think the engines may be the same. Looking at the photo the L shaped hose between the T-stat housing and the water pump I would think could be removed, and a hose from each fitting ran to and from the cab heater. This should provide circulation.<br>
Dan R<br>
<br>
[p]http://i66.photobucket.com/albums/h267/danrob1948/New%20Holland%20TC33D/IMG_1609_zps0f5d7b67.jpg[/p]

Newholland t1510
New Holland Tractors
Replies 6 Post by gotowin

Not familiar with the NT75, but I would suspect the shaft seal on the hydraulic pump as failing. This is usually the closest point at which the hyd. oil and the engine oil get.
Dan Robertson

NT75 Hydraulic oil getting into motor oil
New Holland Tractors
Replies 3 Post by gotowin

check the photo above. I drilled 1/4" holes on both sides of the stabilizer infringing slightly into the rusted tight pin. I didn't feel this hole would jeopardize the integrity of the stabilizer. It also allowed the Aerokroil penetrant along with rosebud tip heat to penetrate between the stabilizer and the rusted pin. That along with 20 tons of press pressure let the pin begin to slip. Also used a hammer on the outside of the stabilizer where I could. I slipped the whole pin, and later reused the pin. after removing the rust the pin was a much better fit going back together. Are you familiar with the Areokroil penetrant? It is the absolute best that I have ever used. Not cheap, and I order online from Kano labs. I highly recommend it.

Lower stabilizer pin rusted in
Case
Replies 9 Post by gotowin

Case tractor bad engineering designs
Case
Replies 9 Post by gotowin

So sorry for the loss of your husband Madam. I feel that more information on your tractor would be helpful. First: has it been maintained over the last 15 years? Oil changes, fuel filter changes, battery replaced, lubrication, radiator and oil cooler cleaned? etc. Has a dealer, you, family member, friend done this maintenance? Will it crank over with the starter? Does the glow plugs work? I recently acquired this 1999 NH TC33D that would not run. Had only 356 hours showing. Had seen terrible neglect, and required extensive repairs. It now runs just fine. You can click the link below to see many pictures of this repair.
Gotowin

tractor was bought brand new in 2000
New Holland Tractors
Replies 4 Post by gotowin

Overheated TC33D Engine Rebuild how to Split
Parts and Repair
Replies 23 Post by gotowin