Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

REPLACED MINE NOT LONGAGO AND HAD NO OTHER MARKING JUST REPLACE THE FACING THE SAME WAY WITH THE TR EITHER FACING TO THE RIGHT OR LEFT SIDE AS THEY CAME OUT

Yanmar 1500 pistons
Yanmar Tractors
Replies 4 Post by cpdtwo

TO TAKE IT OFF IS NOT HARD LITTLE TRICKY TO PUT BACK ON .WOULD NOT OPEN. IF YOU DON'T REPLACE EVERYTHING THE SAME THE TIMMING WILL BE WAY OFF,COST TO HAVE SHOP REBUILD AND REPLACE PARTS WAS $325 LAST NOV 2006.

YM1500 Injection Pump
Yanmar Tractors
Replies 3 Post by cpdtwo

had same trouble on mine went and put new cap on and no more trouble. book say 14lbs I belive but only found a 12lbs on at the auto parts store. and it has worked well. and I live in AZ and it was hot at the time.

yanmar 1500D overheating
Yanmar Tractors
Replies 21 Post by cpdtwo

with all the new parts ,injectors,injector pump, rubuilt motor,3 months ago plus other parts replaced I would only break even selling for parts but give me an offer and we will go from there.

parting out 1500d
Yanmar Tractors
Replies 16 Post by cpdtwo

just replaced the injector pump and still will not start!!!!!!!! getting ready to have a winnie roast guess what i will use for the fire

engine compression
Yanmar Tractors
Replies 31 Post by cpdtwo

good oil bearing not burnt. ckecked oil flow with valve cover off and oilwas pumping fine. I have seen pistons blow before and even cut up but this one looked quite different. even at the top of the sleve where you rean it out I never saw a build up of metel on it.the piston almost didn't come out, had hard time on the bad one going past the build up.

WILL NOT START
Yanmar Tractors
Replies 9 Post by cpdtwo

need to know torque for heads and rods

engine torque for a 1500
Yanmar Tractors
Replies 1 Post by cpdtwo

took it apart somewhat. was able to drop the unit ,remove the lower 6 bolts but could not get it all the way apart. felt around in side with finger and found that the nut holding the wheel shaft was loose. tried to get it tight but was afaird to get it too tight. there was no locking not on the shaft. it looks like someone had rebuilt it before, there where numbers on the out side like a junk yard would use to nake a part. there was no broken parts that i could see and no metal in unit, but the wheel is still is loose. who do it get this all the wat apart to work on it.

ft end loose on 1500
Yanmar Tractors
Replies 3 Post by cpdtwo