Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

Hi, yes im still here! The problem I discovered was a stuck spool. It is located right behind the solenoid that "turns on" the PTO. I just gave it a tap and it started movin again. No problems since. Hope this helps !

JD 4600 rear PTO not shutting off
John Deere Tractors
Replies 8 Post by Ranger350

my 4600 has a fine mesh screen in the trans. and a filter under the left floorboard.

Upgrading Hydraulic suction filter on 4300
John Deere Tractors
Replies 9 Post by Ranger350

Ok, the noise is (or was) the driveshaft shield going to the front axle. Quite loud actually. the PTO problem was a stuck spool right behind the solenoid.

4600 HST noise in C range over 2500rpm
John Deere Tractors
Replies 5 Post by Ranger350

my tractor has been making weird noises when drivin around in C range, say around 2800 rpm, and more pronounced when going down a hill. I think i found it to be the plastic shield whippin around make noise, so i kinda tightened it and i think it went away, then i came loose again. Is the big end near the transmission supposed to fit in the casting a bit, or just sit there? is a hydro unit.

4600 front axle driveshaft shield
John Deere Tractors
Replies 1 Post by Ranger350

Ok guys, after diggin a grave, got home and checked out the brakes, both linkage arms on either side of the engine where the pedals hook up were seized tight. Got one all fixed up, the other side is loosened. It runs mint now. thanks for the info i read in the earlier posts

John Deere 4600 hydro problems
John Deere Tractors
Replies 8 Post by Ranger350