Tractorpoint Login

print < Tractorpoint Login

Tractorpoint

Forums
- Search
- Forums
- New Posts
- Photos
- Manuals/Links
Parts
Support
Account

Search for =

Topic

Willie H.-Thanks for the positive reinforcement! I'm feeling better about the set-up I have. I don't expect it to act like the big stuff......but it beats the heck out of a wheelbarrow & shovel!!! Looking at your pictures I'd say you like to play as much as I do. Mark

2

Kubota backhoe
Loaders Back Hoes
Replies 6 Post by MEY

Thanks fo the reply TomG..I'll try to explain the mount. The hoe has a 1" thick x 4" wide x 14" or so long steel plate that attaches to tractor top link with 2 pins (upper & lower) from hoe mainframe; lower link arms ride over top of 2 1/2" diameter steel tube which is attached to hoe mainframe also. Lower link arms are then pinned to hoe mainframe. Itseems pretty strong but unless I get lower link arm check chains tight ,the hoe will flop left to right some. I have to see if I can maybe get them tight before I pin everything....close tolerance at all connections! Thanks for the safety tip... it does stress in hoe manual about keeping lower link arms down in lower position and not to treat it like a full size back hoe.( I run those at work ) Well, I hope this gives you a pretty good idea what it looks & works like. I just realized I left something out...the check chain turnbuckles practically sit right on the limiter's tube ,thus they have to be tightend before pinning everything. Mark

Full subframe needed
Kubota Tractors
Replies 10 Post by MEY