Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

My dealer was able to confirm through N.H.engineering that the 14LA will not be available until next october. Of coarse i've been waiting since last summer as they said it would be out in the spring time. I can't be out a front loader for any amount of time more less next fall. The 7308 is a good loader and with a slight trist on the valve with a screwdriver, it makes a remarkable difference.

Installing a FEL before or after purchase
New Holland Tractors
Replies 12 Post by KH

Where can I find a dealer for ATI quick attach system for my loader and pallet forks? Thanks

ATI qick attach help
New Holland Tractors
Replies 4 Post by KH

Raider, where id you get your ATI quick attach kit and how much do they cost?

14LA Loader
New Holland Tractors
Replies 5 Post by KH

Thanks for the posts. I have a 02 TC33D w/H.D. bucket.My problem is that I could spend $800.00(gearmore quick connect kit)+$800.00(for pallet forks)=$1600.00. If i'm going that far, I may as well what for the 14LA loader to come out which according to my dealer will have the quick connect on it.All i'll need is the loader as the valve assembly is the same. So i was searching for an alternative soluton. What exactly is the forks with the chains al about and where can they be found? Thanks

pallet forks for 7308
New Holland Tractors
Replies 23 Post by KH

Hello, does anyone know of any manufactorors who provide a quick attach system to interchange between the bucket to pallet forks quickly. Thanks

Quick attach for NH 7308 loader
Loaders Back Hoes
Replies 3 Post by KH

Hello, the Danuser unit is an excellent digger. I too have one with a down force kit. First I line up my auger then drop the 3-pt. hitch all the way down. Then I applie just enough force to the down force ram to put pressure on the auger. Next, I engage the PTO while ajusting the throttle.As it begins digging down, I continue to apllie force to the ram while gauging the PTO speed. Just because it's rated at 540rpm, doesn't mean you have to run it that high. Rather use just the speed that makes it dig efficiently without damaging your unit.

How to operate a Post hole Auger
Operating and Attachments
Replies 6 Post by kh

I have a power down kit on my post hole digger that operates off the rear hydrallics. If I just drop the auger to the ground, then applie full force to the ram, it completily lifts the tractor off of the ground. Therefore, one can see how easily this unit punches holes in the ground.The down force kit runs around $400.00-$500.00. Unless your drilling in loam, this would be a wise purchase.

Power down on 3pt hitch
New Holland Tractors
Replies 9 Post by kh

The 758C doesn't accomodate a 9" bucket. 12" is the smallest. The 757C, however, can use a 9" bucket.

758 C BACKHOE
New Holland Tractors
Replies 2 Post by kh

Hello, what is an approximate of engine hours beore worrying about an overhaul(TC33D)? Also, what would an approx. cost for this service be? Thanks

Engine hours before rebuild
New Holland Tractors
Replies 20 Post by KH