Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

[QUOTE=utcummins;154670] I am new to this forum and in need of some advice.I have a Mitsubishi D2000, the PTO is stuck in the up position and makes this aweful noise.I would not describe the noise as grinding, but its rather loud.Anyway after a day or 2 of siting it will lower itself and once I start it it raises in the up position and will not lower.Does anyone know what might be the problem on this tractor?And if I need to add fluid, where is the plug to do so?Thanks [/QUOTE]

I had the same/similar problem with the 1300, turns out I had to remove the lift section, force out the piston and clean & hone the cylinder and piston, then clean out the valve module, I replaced the 2 o-rings too.

moisture had been getting in at the shifter, I remade a boot for that. the moisture was most of the problem, causing crud and rust in the cylinder that jammed it ....

Tractor PTO will not lower
Mitsubishi
Replies 7 Post by JDwannabe

Yes it IS,

just open it up and fill at the top inlet till there begins a bit coming out this plug and then put the plug back in.
Just like ncw said.

Mitsubishi MT160 hydraulic oil fill line
Mitsubishi
Replies 8 Post by JDwannabe