Tractorpoint Login

print < Tractorpoint Login

Tractorpoint

Forums
- Search
- Forums
- New Posts
- Photos
- Manuals/Links
Parts
Support
Account

Search for =

Topic

Hi folks, I have noticed over the last 6 months that I have had to pull the 3pt Lift lever back further and further before the linkage will start to lift my mower on the back. Today I pulled the lever right back to the top of the slot in the housing and the linkage did not even start to move. I removed the housing and tested moving the lever further back and yes the linkage lifted up fine. Has some slippage occurred internally somewhere? I see that one nut holds the lifting lever onto the shaft which rotates into the hydraulic system. I removed this nut but the lifting lever would not slide off the shaft(should it slide off?). Secondly I see there is an adjustable shaft which links the right hand side (from the rear) lifting arm through to a lever mounted on the hydraulic system just under where the lifting lever shaft is. This lever is all bent out of shape - could this be causing my 3pt lift failure problems and if not what is it for (does it matter it is bent out of shape)? Thanks for your help as I dont have any owners manual..Craig in NZ

B8200 3pt Lift failure
Kubota Tractors
Replies 3 Post by Craigdav