Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

There's no doubt the used parts are out there somewhere but if you can't locate them and it would be more time, work, and money to convert/adapt the front axle to the newer design, you can try taking your parts to a machine shop. It might be possible for new splines to be machined, have the ends beveled where the new splines would join together with the adjoining part, and then weld them. With the joining ends being beveled, this allows more surface area of the weld being penetrated between the 2 halves. Have the machinist rockwell your axle/spline for hardness and then see if they have the right material that can be cut with a carbide cutter. If not, might have to heat treat the piece after it's machined. ...but then again this is the 4wd axles and so you might not be comfortable with the possibilities of it breaking due to the higher torque on it versus it just being a standard 2wd front end axle.

MF205-4 anyone
Massey Ferguson Tractors
Replies 11 Post by CountryFolk

Ford 3600 Hydraulics Top Cover 3pt Lift Cylinder Slector Valve
Antique Tractors
Replies 10 Post by CountryFolk

Ford 3600 Hydraulics Top Cover 3pt Lift Cylinder Slector Valve
Parts and Repair
Replies 10 Post by CountryFolk