Need increased loader height for JD 855 w 70 loader
1Miller
Join Date: Posts: 1 |
2003-02-24 49898
I have a JD 855 from mid 1990? # 70 loader? I would like to be able to use it to load my 1977 F-600 dump truck, however the lift from this tractor/loader leaves me about 4 inches+ to low from being able to clear the top of the dump bed on the truck. Is there any way to increase the lift or height of this tractor? Maybee different wheels and tires, different loader, anything? or any ideas would be greatly appreciated as this is a very handy combo to have. Thanks, Jon.
Reply to | Quote Reply | Add Photo
Need increased loader height for JD 855 w 70 loader
dsg
Join Date: Jun 1999 Posts: 528 Franklin, Maine Pics |
2003-02-24 49911
Jon,
Build a ramp with gravel or whatever you're loading.
David ....
Reply to | Quote Reply | Add Photo
Need increased loader height for JD 855 w 70 loader
Dana Trumpp
Join Date: Posts: 1 |
2003-02-24 49924
Yes a ramp will do it, but you will only be able to load the sides of the truck since the loader is not long enough to reach the center of the bed. ....
Reply to | Quote Reply | Add Photo
Need increased loader height for JD 855 w 70 loader
harvey
Join Date: Sep 2000 Posts: 1550 Moravia, NY Pics |
2003-02-25 49948
Me thinks you already know the real answer to problem. Until you have the money to upgrade. Try loading over the back. If you lift the box partially you will be able to get quit a bit in there. We load big dumps on job sites this way with small loaders, ie: skid steers, smaller backhoes. If you have to load over the side you can dig a shallow hole and refill when you finish the chore.
Harvey ....
Reply to | Quote Reply | Add Photo
Need increased loader height for JD 855 w 70 loader
TomG
Join Date: Feb 2002 Posts: 5406 Upper Ottawa Valley |
2003-02-25 49952
One of the things I didn't get done (for some years now) is building a loading dock. In my case it's easy since there already is a cut on our drive. I'd simply have to dig back to get a section of cut that's vertical and build a retaining wall.
If the loading is always done at one location and there's a convenient hill, that might be an additional alternative to the good suggestions made. One side of the dump could be loaded and then the truck turned around and the other side loaded. If a dock was fairly high then the loader would be able to reach closer to the centre of the dump bed.
I imagine the tractor already has a grill guard if this sort of work is contemplated 'cause it sounds like otherwise there'd be great potential for mashing the rad.
....
Reply to | Quote Reply | Add Photo
Need increased loader height for JD 855 w 70 loader
1Miller
Join Date: Posts: 1 |
2003-02-27 50177
Thanks to all for your suggestions, Jon. ....
Reply to | Quote Reply | Add Photo
Go Top
Share This