Go BottomWoods 7500 Backhoe Stabilizer arm is Pinching the Hydraulic Hose
 | Mark Sturges
Join Date: Posts: 1 
|
2000-04-02 14378
Has anyone had consistent breakage problems on the hydraulic hose that runs between the stabilizer arm and the inner portion of the hydraulic cylinder head. It seems to get pinched, and eventually wear through the rubber housing and then the inner mesh housing.Any thoughts would be appreciated.
Reply to |
Quote Reply |
Add PhotoWoods 7500 Backhoe Stabilizer arm is Pinching the Hydraulic Hose
| Paul Hastings
Join Date: Posts: 1
|
2000-05-30 16785
Mark,
My name is Paul Hastings and I'm an engineer for Woods. I'd like to talk to you about your hose failures if I may. Could you give me a call during normal business hours? I can be reached at (800) 435-7242 ext 2361#. When you call ignor the recording, just dial my extention and hit the # button. If I'm not at my desk, leave your number and I will call you back. ....
Reply to |
Quote Reply |
Add PhotoWoods 7500 Backhoe Stabilizer arm is Pinching the Hydraulic Hose
| Ron Mitchell
Join Date: Posts: 1
|
2000-06-01 16823
Hi - I just had a similar problem with a J-D #7 backhoe. The hose was stretching too tight and being rubbed on the thru-bolt for the rotation cylinder on the right side. Left hose was in a similar condition at very low hours. J-D picked up most of the cost of new hoses and labour. The original zip ties were keeping slack from being pulled, making the hoses too tight. Good luck, hope you can get a similar hand with it. Ron ....
Reply to |
Quote Reply |
Add Photo
Go Top
Share This