Go BottomMassey Ferguson 1042 Tractor with Hinomoto Engine
 | ChaseB
Join Date: Jan 2012 Posts: 8 Missouri 
|
2012-01-06 181914
I bought a tractor that has Massey Ferguson 1042 on its hood,..but cant find any literature on a 1042, after doing some searching on the tractor , the steering wheel says Hinomoto on it,..serial number is 00163,..fuel filter.wix 33390,..it has 2 hydraulic filters wix51664 and oil filter wix51346
tag on left side of transmission has
........304
......00163
......3S150
It's 4x4, the drive shaft for the front axle is enclosed and comes from the rear axle housing, front tires size 7.50x16, back tires 13.6 x26
it is a 4 speed trans with S(start) position, 3 speed transfercase ( up is high,middle is low bottom is medium,2 speed rear end, with dif. lock and a 3 speed PTO .
dimensions of tractor are center to center of front &rear axles 6ft,..rear fenders outside to outside 58"
hood length down the center front to rear 49.5 "
it has a loader,..but I think it is an after thought,..not OEM
motor is a 3 cylinder diesel
anyone that thinks they know what it is,..hook up with me,..I'll send a photo
Chase
Reply to |
Quote Reply |
Add PhotoMassey Ferguson 1042 Tractor with Hinomoto Engine
| ChaseB
Join Date: Jan 2012 Posts: 8 Missouri
|
2012-01-06 181917
ok narrowed it down just reading posts,..the motor 3S150 is used in hinomoto E324 and E2804 tractors ....
Reply to |
Quote Reply |
Add PhotoMassey Ferguson 1042 Tractor with Hinomoto Engine
| ChaseB
Join Date: Jan 2012 Posts: 8 Missouri
|
2012-01-06 181918
another hint to the model,..I read that the E2804 has an aluminum bell housing,..a quick magnet check told me it is not aluminum,.t is cast iron,.so chances are my tractor is an E324 ....
Reply to |
Quote Reply |
Add PhotoMassey Ferguson 1042 Tractor with Hinomoto Engine
| ChaseB
Join Date: Jan 2012 Posts: 8 Missouri
|
2012-01-06 181921
OK pretty sure its an E324,..changed the oil,..hydraulic oil looks new,..but there is a cap on the housing that the injector pump is mounted to,..when I remove the cap I can see the gear drive for the injector pump,..I can not find a capacity for this capped reservoir,..does it draw fluid from the hydraulic system?,..is it it's own reservoir,..which I'm leaning towards because it has it's own cap,..if it is a seperate reservoir,..what is the fluid required and capacity??
thanks for your help :) ....
Reply to |
Quote Reply |
Add PhotoMassey Ferguson 1042 Tractor with Hinomoto Engine
| ChaseB
Join Date: Jan 2012 Posts: 8 Missouri
|
2012-01-06 181923
OK evidently the crank case oil lubes the injector pump,..and I have an extra oil cap location depending on my mood as to which one I use I suppose,..
BUT,..now that I have it running and I did a little pushing horse crap with it,..it doesnt like to steer with a load in the bucket,..so my questions now steer (no pun intended) towards the power steering,..is there a screen? or seperate filter for the power sterring?? ,..the casse or cast iron housing says "Toyoda" on the left side ....
Reply to |
Quote Reply |
Add PhotoMassey Ferguson 1042 Tractor with Hinomoto Engine
| ChaseB
Join Date: Jan 2012 Posts: 8 Missouri
|
2012-01-13 182073
the motor is a toyosha 3S150 3 cylinder diesel ,..still havent found actual HP rating for this motor ....
Reply to |
Quote Reply |
Add PhotoMassey Ferguson 1042 Tractor with Hinomoto Engine
| ORfrmr
Join Date: Dec 2012 Posts: 2 SoCal high desert
|
2012-12-05 185608
Just read your thread. Your tractor sounds identical to my Hinomoto E324, including the steering issue that you were experiencing. For me, that turned out to be a nasty problem with the bearings and the cast iron housing that holds them. (There had been previous damage, and previous repair work in there.) The bottom line for me is that I now need to find parts that are probably going to be tough to get. ....
Reply to |
Quote Reply |
Add PhotoMassey Ferguson 1042 Tractor with Hinomoto Engine
 | lsheaffer
Join Date: Jun 1999 Posts: 1082 Northern Illinois 
 Pics
|
2012-12-06 185623
Does it have powersteering? ....
Reply to |
Quote Reply |
Add PhotoMassey Ferguson 1042 Tractor with Hinomoto Engine
| Dougdamewood
Join Date: Jan 2017 Posts: 3
|
2017-01-09 196074
I have a hinomoto E324 and him having trouble getting the three point hitch to go up The bucket on the tractor another hydraulics work fine Has anyone had similar problems ....
Reply to |
Quote Reply |
Add PhotoMassey Ferguson 1042 Tractor with Hinomoto Engine
 | Murf
Join Date: Dec 1999 Posts: 7249 Toronto Area, Ontario, Canada 
Pics
|
2017-01-09 196076
Hi Doug,
Welcome to the board!
The thread you replied to is a flaw years old, but no matter.
The hydraulics for the 3pth are separate from other functions. There is likely a control knob under the seat between your feet as you sit on the tractor. Check that it has not been turned all the way closed. It is meant to control the speed the 3pth goes down at, but if closed all the way will freeze it completely.
Best of luck. ....
Reply to |
Quote Reply |
Add Photo
Go Top
Share This