Go Bottom Go Bottom

John deere amt600 5 Wheel gator

View my Photos
joestruck
Join Date: Apr 2008
Posts: 6 St. Cloud Fl.
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2008-04-04          152736

I have an amt 600 5 wheeler and I just got knew break pads for the back I went through and followed the directions that came with them but there is not enough room with both pads loaded in caliper to get it over the disk. I have both sides adjustek all the way out with the adjuster on back of caliper and both pistons look the same distance when all the way in I just cant get them to go on there is a little rust on disk but not that much any help would be great thanks a lot. Joe

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



John deere amt600 5 Wheel gator

View my Photos
kwschumm
Join Date: Feb 2003
Posts: 5764 NW Oregon
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2008-04-04          152741

I don't know about the Gator, this might sound stupid but are the brakes hydraulic? If so you might have to crack the bleeder a bit so the pistons can be pushed further in and then tighten it up right away to keep any air from being sucked into the system. ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



John deere amt600 5 Wheel gator

View my Photos
kthompson
Join Date: Oct 2005
Posts: 5275 South Carolina
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2008-04-04          152743

Joe, I am with Ken, not sure of the set up on Gator brakes but I have had to use a "C" clamp to pull the pistons back into the cyl for clearance on disk brakes before. Be sure you system is not sealed if you do so as there will be fluid needing to escape. kt ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



John deere amt600 5 Wheel gator

View my Photos
joestruck
Join Date: Apr 2008
Posts: 6 St. Cloud Fl.
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2008-04-04          152746

these breaks are cable operated and they are adjusted with a screw on back of caliper that pulls piston into bore my brother put them on he said he took the caliper bolts lose and took it appart to get them over the disk so I may try that to marrow any more ideas would be great thanks a lot. Joe ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



John deere amt600 5 Wheel gator

View my Photos
dhoward
Join Date: May 2008
Posts: 2 Jonesboro, In
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2008-05-12          153658

Can you please tell me where you purchased the brake pads for amt 600? Thank You Denton ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



John deere amt600 5 Wheel gator

View my Photos
joestruck
Join Date: Apr 2008
Posts: 6 St. Cloud Fl.
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2008-05-13          153663

I was able to go right to my johndeere dealer and told him what i needed for that machine and he found them and had them next day if you have any trouble I may have the package mine came in i will have to check to see if i can get the part number off of it good luck. ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



John deere amt600 5 Wheel gator

View my Photos
karbinator
Join Date: Oct 2008
Posts: 8 east cost
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2008-10-19          157367

Prvious owner removed the Amt 600 I now have, and I'm not certain where they go. Could someone here tell which wires go where comparing theirs/?>

Thanks ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



John deere amt600 5 Wheel gator

View my Photos
karbinator
Join Date: Oct 2008
Posts: 8 east cost
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2008-10-19          157368

Sorry i'm referring to the starter for the AMT600 I can't figure out where the wires go to which posts on the solenoid.

Thanks ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



John deere amt600 5 Wheel gator

View my Photos
johandes
Join Date: Nov 2008
Posts: 4 Arroyo Grande, California
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2008-11-01          157615

I have a factory wiring diagram that I can probably scan and send to you if you haven't figured it out yet. Let me know. You can contact me at johandes@aol.com Jim ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



John deere amt600 5 Wheel gator

View my Photos
fernand
Join Date: Sep 2009
Posts: 3 NW Ontario
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2009-09-26          165964

johandes
If you still have that factory wiring diagram I sure would appreciate a copy. Just bought this used AMT 600 and it will only start by shorting at the starter. Thank you. ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



John deere amt600 5 Wheel gator

View my Photos
johandes
Join Date: Nov 2008
Posts: 4 Arroyo Grande, California
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2009-10-13          166313

Sorry about the delay in getting back to you. Yes, I still have the wiring diagram. Contact me at my email address. See above. Jim ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



John deere amt600 5 Wheel gator

View my Photos
johandes
Join Date: Nov 2008
Posts: 4 Arroyo Grande, California
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2009-10-13          166314

Sorry about the delay in getting back to you. Yes, I still have the wiring diagram. Contact me at my email address. See above. Jim ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



John deere amt600 5 Wheel gator

View my Photos
fernand
Join Date: Sep 2009
Posts: 3 NW Ontario
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2009-10-13          166324

Johandes,
Thankyou for your reply.
I recently purchased a Tech mannual for the AMT 600 so am off to the races.
fernand
PS
For those of you who require tech info for your machine John Deere Mannuals on line provide a good service at a fair price of $25 for life time access or $35 for your mannual on CD. ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



John deere amt600 5 Wheel gator

View my Photos
johnnylabguy
Join Date: Mar 2011
Posts: 4 Mid Ohio
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2011-03-11          177351

So how did you fix your problem fernand? I've just purchased an AMT600 with the same problem(jumping at the solenoid). I'm wondering if I just bought your old machine!:) Your a long way from mid-ohio though. Thanks for any input! ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



John deere amt600 5 Wheel gator

View my Photos
Marlenenaylor
Join Date: Oct 2021
Posts: 1 smithville wv
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2021-10-17          200753

Need wiring diagram please ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo


  Go Top Go Top

Share This
Share This







Member Login