Go Bottom Go Bottom

Golden Jubilee pivot pin

View my Photos
loafersglory
Join Date: Sep 2014
Posts: 4 United States
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2014-09-28          191126

I am replacing the pivot pin on my Golden Jubilee tractor. The plate with three dimples was on the back side of the front support. It was secured with the pivot pin bolt and a larger bolt through bottom hole. This sandwiched the front support between the pivot pin flange and dimpled plate. Next was a spacer ring then the center axle. I believe the plate should be on front side of front support as indicated by welds. The I&T shop manual says to discard washers in front and back of the center axle. My plan was to weld the plate on front support and install the center axle on the pivot pin with no washers or spacers. Would this be correct? What are the holes on the spacer ring for? Thanks, Allen

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



Golden Jubilee pivot pin

View my Photos
yocsr1
Join Date: Dec 2013
Posts: 182 Terre Haute, Indiana
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2014-09-28          191130

I went out and looked at mine. It's got the main plate,two washers, pivot arm, two washers, outer plate, reverse teardrop plate. I personally would keep the washers, just for the reason of smoother movement and keep any wear on the washers not the plate or arm. I was curious as to why yours needs replaced. Mines in good shape. Larry.
....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo


  Go Top Go Top

Share This
Share This







Member Login