Tractorpoint Search for

Search for =

Topic

I’m with SG and DSG, let’s reform the tax codes and make everyone pay their fair share.

There’s 0ver 43 million tax filing Americans that didn’t pay a single dime in federal taxes. Let’s kick all the free loading scum buckets out!

New Tax being created
Everything and Anything
Replies 10 Post by jdcman

AV8R,

Socialism is already heavily embedded in the US culture. Make no mistake about it we are an entitlement based state. You need look no further than the current federal tax statutes.

The party that steps up and cuts from the herd to demand that every American pay their share to support this country gets my vote.

You cut out this socialism and entitlement crap and the bugs will stop trying to get into house.

Unfortunately I doubt that either party will support the fiscal or social reforms needed to right the ship.

Limiting Eminent Domain
Everything and Anything
Replies 42 Post by jdcman

Sorry you feel that way Chief, re-read my post. <br>
<br>
Some of my post is a carry over from a prior discussion re the socialistic nature of the tax codes. Wing has a position, so do I.<br>
<br>
Here’s my points to Wing:<br>
<br>
Wearing a uniform isn’t a prerequisite for Patriotism. <br>
<br>
Plenty of people make contributions in other ways. Their opinions are just as valid. Never said anything about people of service, just Wing. All based on his personal comments and my interpretation of those.<br>
<br>
Socialism is bipartisan. Liberals and the Democratic Party don’t have sole claim.<br>
<br>
The ultimate “down bringing” of this country will be poor economics, not terrorism.<br>

America The Greatest Country on Earth
Everything and Anything
Replies 83 Post by jdcman

<br>
the way i look at it: is if you got what you wanted and you're happy what difference does it make what you paid for it. it's your money.

4710
John Deere Tractors
Replies 4 Post by jdcman

$Willie, The TIG / Arc Welder is basically what is referred to as a Constant Current power supply. The difference between the “inverter” machines and the traditional “transformer” machines is in the technique used to transform the energy from 220 volt inlet side, (wall connection), to the regulated constant current on the output side, (electrode). These machines are nothing more than giant versions of the power supplies that are in most everyday electronic gizmos found around the house. Almost all modern day electronic equipment use “switching” power supplies vs the older analog supplies that use big bulky multi tap transformers and regulators. Inverters welders are a fraction of the size of the older transformer types. Mid range inverter machines are typically more efficient than the older transformer based guys as well. Both types of machines can be bought with lots of bells and whistles that make the job of TIG welding a little bit easier, i.e., pulse wave form shaping, AC waveform offset control, timers, gas and water control solenoids, ect.. But the most useful feature available only on the Inverter type of machine is the ability to control the AC frequency. This is a big feature for AC work, i.e., AL. Meaningless in DC mode. This feature provides a nice focused arc, hence giving the welder better control of the puddle when working with AL. There are a couple of down sides to the new Inverters --- 1) Duty cycle tends to be less at the higher output ranges. 2) The guts of the Inverter is electronics. Big MOS Pwr Devices do the switching. So the verdic is still out as to how well they will last over time. There’s lots of Transformer based machines of 40 yr vintage still out there working everyday. I don’t know if the same will be said of these inverters 40 yrs from now. As I said in a previous post, I have had several transformer based machines and about two yrs ago purchased an inverter because of it’s small size and portability. It's great machine and as of yet have no regrets. Hope this helps.$ Welding Aluminum
Parts and Repair
Replies 23 Post by jdcman