Tractorpoint Search for

tractorpoint.com - The leader in Tractors from Compacts, to Utility, to Full Size Tractors! Kubota, John Deere, New Holland, Kioti, Case/IH, and Others. Keywords=Compact Tractor, Kubota Tractors, Kioti Tractors, JD, John Deere Tractors, New Holland, Case Boomer, Used Tractors, Classifieds, Dealer Directory, Tractor Pictures / Images

parts | discussion | photos | podcast | reviews | specs | dealers | classifieds | contact | faq | myProfile | home Login Now | Sign Up

Search for =

Topic

Found this place on the internet that sells some pretty neat equipment.

Best Pressure Washer for Father s Day
Home Improvement
Replies 62 Post by Chief

On my B2710 you have two control levers for the pto's,one for the rear and one for the mid.You just pin the mower in the raised position and then use the three point like normal no need to unhook the pto shaft.I beleave the B7800,B2710 and B2910 are all the same.

B7800 Mid PTO Rear PTO operation
Kubota Tractors
Replies 10 Post by freydo

I know where a 650 with NO belly mower, but a rear 60" mower, and a rear tiller, and they say it has only "150" hours for $5000.00.

JD 655 2WD Diesel w 48 quot deck gentlmn29 aol com
John Deere Tractors
Replies 6 Post by boneidaho

I was just wondering if the JD 655 2WD diesel w/48" deck is a good tractor and if it is worth $4900 with 831 hrs on it.

Thanks Brett

JD 655 2WD Diesel w 48 quot deck
John Deere Tractors
Replies 1 Post by Bretthawk

With the hood latch under the steering wheel it would have been a BX something.

Actually, in re-reading my post, I should have said the battery lies between the operators knees, but the effect is the same.

Overheated 2210
John Deere Tractors
Replies 36 Post by DRankin

I am in Buckley if you are selling your B21.

b21 how much to ask washington state
Kubota Tractors
Replies 9 Post by torohog

bvbilski<br>
Me either, no I bought last week from OK tractors, corriher impliment co. in Newton NC. In fact it left their dock just this morning on its way to my home in Monroe MI.<br>
I bought A TC-30, nh-7308fel, loaded R-4 tires (9x3)trans<br>
$14050.00,delivered to my home for $600.00 should be at my house no later than Monday, can't wait. No dealer in SE michigan or NW ohio could get under $16000, go figure? and I gave them lots of chances, I have wanted a compact since 1998 when we bought land and built a home, in fact I had a deal done on a 1720 with the same loader before the house was done but my wife and dad were freaking out about me spending that kind of money " on a lawn mower" so I played the garden tractor game. I should have bought then and did some of the fill, grade and plant work myself instead of hiring it out. then I might be able to afford a $5000 tree spade. <br>
I now have friends with kabuta's, deere's and new holland's full size and compacts and they are all good machines It is just how much power ,how many bells and whistles you want, and keep working the best deal. this one will not finish mow It will rough mow 4ac. till, light loader work, post holes, and hopefully move trees. we have 7.5ac and two horses, I want to build another pole barn,this one myself for myself. and a small greenhouse. <br>
In spring of 1999 we bought and planted 350 trees planted them all together to make it easier to take care of them, as advised. I have moved and/or killed about 50 of them by hand. So this tractor will solve my tree problem one way or another, remember that rough mower and tiller I talked about. Anyway good luck with your tractor puchase.

Tree spade for 460 loader
John Deere Tractors
Replies 8 Post by hockeyhead

The L-3830GST retails for $19536. The loader is $4890.with the QT for the 72" bucket. The HST starts at $20,036. About 500. difference the way I see it.

L3830 price
Kubota Tractors
Replies 6 Post by Art White

I used Amsoil for a long time in automotive engines and had great results. In the mid eighties I bought a new car. After the break-in period I wanted to put Amsoil in it and was told by the dealer that it would void the warranty because the oil was not SAE rated. Is that still true?

4000 Ten Series 50 hour break in service
John Deere Tractors
Replies 71 Post by kwschumm

it sounds like the ratchet and the rack on the pedel might be out of alingment.when you step off you put pressure on one side and it slips off.look under the floor board to see if everthing is square.good luck

Parking brake problem
New Holland Tractors
Replies 4 Post by sodman

valid points on weight and hydraulics, but these things shown on skidsteers all over the place and I don't see them weighing more that a compact with loaded tires, and skidsteers hydraulic systems are that much stronger? I found a couple makers of 24" hydraulic tree spades with 3ph hookups but we are still looking at $5000 plus, and one sites spec. sheet stated for 45hp and above tractors, which appears to be a very general spec. Since I will not spend 5 grand and my tractor is to light I'm back to the $2200, 24" tree toad which only uses tractor hydraulics to lift and carry ,and set,the tree, more research required, hey Willie H, I will buy it, move my trees and, then sell it to you <br>

looking at a tree spade for my tc-30
Operating and Attachments
Replies 7 Post by hockeyhead

Help, can someone tell me the right valve to use on a Yanmar 155D tractor with a new FEL. I,m ready to complete the hydraulic hookup, but am now told that this might not work. The valve I would like to use is a double spool type,open center with a single acting spool installed on one side to accomadate the single acting lift cylinders.
Pressure line enters the inlet side of valve, and exits from outlet side and continues back to the 3 point hitch
valve. Will this work or do I need power beyond type valve.
Will the 3 ph work when loader is not being in operation.
Thanks for any help. Dean

Loader valve
Yanmar Tractors
Replies 2 Post by dietmar

wish I would of went with the 6 footer , having some blade outside the tires would make grading go a lot easier as Tom stated.

Largest size landscaping box for B7800
Kubota Tractors
Replies 8 Post by plots1

My folks were in a brush fire in California that burnt houses to wiothin a block. It didn't take them long after that to take off the shake roof and put on a tile one at considerable expense. Attractive and incombustible (not withstanding the walls and very wide-eaves mentioned). I never was sure how I felt about having that much weight over my head in an earthquake area though.

AC: The two minutes idea still may be a pretty good target. I think the reality is that direct attack has to be successful in a very short time or it's not going to work. We have two 1.5" hoses mounted on our pumper with fogger nozzles just in case we can knock one down. More frequently a fire is established when we get to it and we use 'surround and drown' techniques that require more water and pumped over longer periods.

Thanks for the pump explanation--that's what it probably is. I do think that 28gpm is pretty small high pressure or not to be really effective for direct attack. However, the pump is what I'll likely end up with if I can't find a bigger one that's priced around $500.

It might be worth noting that our Volunteer Dept. also has to deal with low flow water sources and you can't drive the pumper close enough to many sources anyway. We purchased a folding 1,500-gallon water tank. The idea is that a portable pump fills the tank continuously and the pumper pumps from the tank. However, this type of thing probably is what fire services rather than individuals should have.

Living in the Fire Zone
Parts and Repair
Replies 52 Post by TomG

Aha! Clever; and I said I was into small tricks yesterday. The plastic ends up on top too and that's even better. Salvaging topsoil is a problem and there's not much of it around here to start with.

I imagine that some dirt might have to be pushed off the top first for deep trenches or the tarps would tear. No problem real problem and much easier than pulling plastic out of the hole. That's what I'll try next time. I suspect that I might need something wider than 4' for deep trenches to get enough wrap around.

Last fall I broke 1/4" hardware store plastic rope while dragging a huge pile of leafs in a large tarp. I guessing that with 3/8" rope the tarp probably would have torn. Army tarps probably are tougher than box store ones though.

Box Scraper Landscaping Box
Operating and Attachments
Replies 11 Post by TomG

Thanks Mike! I just bought a 29D, hasn't even been delivered yet. After reading the 29 vs. 33 postings I was getting a little scared that I'd made a mistake. My dealer never even tried to get me into a 33, said this'll do everything I'll ask of it (7308, Bradco 3375 bh, 60" box).

TC29D Ownership
New Holland Tractors
Replies 3 Post by matman

kennyd -
How did you ever make out with your PHD? I have a Leinbach PHD L7300 model on the back of my orange. I have had it now for about 4 years...put in alot of telephone pole cutoffs for fence posts.

I had my choice of auger sizes when I bought it new, I grabbed the 9" auger which gives me about a 10" -11" diameter hole. Works great! Paid $300 for it.

Willie H.

Post-Hole Digger Recommendation-Kubota BX2200
Operating and Attachments
Replies 14 Post by WillieH

5', 5 scarifiers.

Pyramid Implements
Operating and Attachments
Replies 3 Post by dmnsmith2

mine was a guess,sorry,,I was not saying that is the price

TC33D
New Holland Tractors
Replies 7 Post by stevenc

The GF1800 on ebay is not a 4 wheel drive. I would estimate the unit to be worth about $5000.00. I had the opportunity to buy a new GF1800 2WD from a dealer last year for $8000.00.

2 wheel drive units are worth much less than the 4WD machines. Also, front mounted mowers have taken a beaten in price since the ZTR's have come out. Most people like the ZTR units much better. I like the ZTR's much better than the front mounted mowers.

Jon

Price on Kubota GF 1800
Kubota Tractors
Replies 2 Post by littlediesel