Go Bottom

WTK Pinion king pin shaft orientation on front drive CaseIH 275MFD

View my Photos
nemein
Join Date: May 2009
Posts: 10 florida
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2009-10-31          166639


I am in the process of installing new hubs on a Case IH 275 MFD 4 wheel drive tractor. My tractor was built by Mitsubishi and badged as a Case and use the same or very similar front drives.
My question concerns the pinion or king pin shaft that drives the front wheels, part #1962152C1. The splines on one end have a stop that prevents the gear from moving beyond a point on the shaft. The other end does not have this, the gear can move all the way to the bevel where the splines taper to the shaft toward the middle.
Should the end with the stop on the splines go to the top or to the bottom of the spindle.
I can send pictures if it helps and any help would be greatly appreciated.
Thank you in advance,
Mike




Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo


   Go Top


Share This







Member Login