Go Bottom

Pincor generator

View my Photos
danwhitworth
Join Date: Sep 2003
Posts: 30 Mississippi
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2009-01-08          159219


I have a 3000W Pincor with a 8hp B&S electeic start. I was getting no output so I removed the end cap and the cermanic (?) resistor is broken in half, as the brushes are attached to this I am assumming that is the problem. Every parts place I checked online states Pincor parts are not available. My options seem to be buy a salvage piece or sell mine for salvage. Any info appreciated. Thanks. Dan



Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



Pincor generator

View my Photos
kwschumm
Join Date: Feb 2003
Posts: 5764 NW Oregon
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2009-01-08          159220


Can you read the resistor value off the broken one? Maybe you can buy a new resistor and solder in a replacement. Seems worth a try. ....


Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



Pincor generator

View my Photos
kwschumm
Join Date: Feb 2003
Posts: 5764 NW Oregon
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2009-01-08          159221


By the way, it's possible the resistor broke because there is too much slop in the bearings. If armature shaft wobbles back and forth in loose bearings the vibration could have broken the resistor, or something else. Some inexpensive generators (Coleman) use cheap nylon bearings that have caused all sorts of problems. ....


Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



Pincor generator

View my Photos
AnnBrush
Join Date: Mar 2004
Posts: 463 Troy OH
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2009-01-08          159223


This is one of those cases where a picture would be worth a thousand words. If you can take it to an industrial electric repair shop or motor winder they will be able to repair it for you if it it worth repairing. ....


Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



Pincor generator

View my Photos
candoarms
Join Date: Mar 2007
Posts: 1932 North Dakota
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2009-01-08          159226


Danwhitworth,

I agree with AnnBrush. If you were to take this generator into a repair shop, they'd probably be able to repair it for you for very little money.

They'll quickly identify the bad part (fusible link?) and replace it for you.

Joel ....


Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



Pincor generator

View my Photos
earthwrks
Join Date: Dec 2003
Posts: 3853 Home Office in Flat Rock, Michigan
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2009-01-09          159250


Being a small output genny, I'd look up a good mower and power equipment repair shop that works on homeowner-type gennys. My Generac when new blew what was called the "diode pack" which sounds like what you are describing which was on the very end. It was a $30 part. It's possible Coleman or a host of other mfg's use the same part. ....


Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo


   Go Top


Share This







Member Login