PTO shaft repairs
karlpe
Join Date: Oct 2005 Posts: 1 New Iberia Louisiana |
2005-10-27 118525
I own a Woods model MD-184 rotary cutter and I have a PTO shaft that is worn severely in the Square drive female end. The square shaft has very little wear. This Weld-on adaptor is 1 ½ square and I am having problems finding this size. I can easily find 1 Ό and smaller but no luck with 1 ½. If I can find this adaptor then my repair cost would be much lower than down sizing to the smaller shaft where I would have nearly the expense of a new PTO shaft. Another problem with the woods mower is that the slip clutch ( OEM part) that has a #35 u joint half yoke welded to it , so that further complicates the problem. I dont understand why woods would use such a large shaft on a 7 brushog and why in the world would they make a slip clutch without a spline drive. It has really been a good mower and this is really the only problem that I have had with it. Do you have any suggestions of where I might locate this weld on 1 ½ square drive adaptor?
Thanks Karl
Reply to | Quote Reply | Add Photo
PTO shaft repairs
Murf
Join Date: Dec 1999 Posts: 7249 Toronto Area, Ontario, Canada Pics |
2005-10-27 118526
Karl, I really think there are lots of places closer, but the link below is to the people we use up here.
They are really good, honest, knowledgeable people, I've never had a problem with them in 20 years.
No affiliation at all, just a happy customer.
Best of luck.
....
Link: Bauman Manufacturing Limited.
 
Reply to | Quote Reply | Add Photo
Go Top
Share This