Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

after reading good advice,started at battery.2007 replaced it. cable ends where cone shaped inside, replaced cable ends(battery clamps) lights come on,but keeps blowing ignition fuse .start cleaning ignition terminals,fuse box terminals,remove and clean fuses, unbelievable amounts of dirt and grime mixed with loads of grass. now when turning key I get a click but it does not blow the fuse,ithen clean the connection on the seat switch(the seat switch does not stop the tractor from starting,it only shuts the tractor down when pressure is reliesed while pto is engadged)now I turn the key and no click the starter trys to engadge and the lights dim, so I blast the new battery with 200 starting amps and it fires up thank you so much for the expert advice saved me at least $400.00 just for the dealer to come get it and look at it im starting to like this internet thing

John Deere 4310 electrical short
John Deere Tractors
Replies 5 Post by jdurb1

when this happened to me there was an adjuster that lets the pto drop fall very fast to not at all I had turned it tight thinking I was adjusting the seat

3 point hitch hydraulic system
Jinma Farmpro Agracat Nortrac
Replies 8 Post by jdurb1

the load match I believe is only for using a bucket. if that button is pushed it will activate the code .if you bump the cruise it will activate mine is usually allways flashing. when the code is for real the tractor will be stuck in 4wd and that can cause jerking. when it wont move well or stiff turning it will activate the code but if 4wd is working properly it is usually the suction filter. and when low on hydro fluid it will do all kinds of funny things I would also go through all fuses moving from port to port can detect a problem when and if the sensor does go it is a difficult pain I took mine in and it cost me 120.00 I really cant remember at my age but I may have told them to just remove the stupid sensor

4310 Load Match Jerking while driving
John Deere Tractors
Replies 12 Post by jdurb1

put the coil on today and it runs perfect 500.00 for a 2004 gator with 3500 hours 500.00 for all new tires 10. one new valve, 25.00 fuel pump, 200.00 carb, 120.00 coil with built in ignitor , primary clutch free, secondary clutch 230.00 total 1600.00 for a very clean mechanicly sound gator im very happy today thank you for the help

ignitor
Utility Vehicles UTV/ATV
Replies 5 Post by jdurb1

if its zoned ag no permits should be required tell the tax assessor to stay off property he can view google earth. use manufactured trusses as you need something to screw drywall ceiling into 2 ft on center fill space between perlins with 1 1/2 in foam board house wrap and tape every thig with gorilla tape this will keep bugs from getting through tin and give increadable insulation value.i ran flex ducts through attic as there is no crawl space run water lines inside of house they cannot go inside of walls because they will freeze at every post only thing under house is 1 very large drain. backfill all the way around building with gravel not dirt or you will have a colonie of mice . love my barn house built it 10 years ago alone with no help cost 15000.00 plus well and septic witch I hired out .another big plus is low taxes

Pole Barn advice and help before building
Barns Pole Barns
Replies 4 Post by jdurb1

blue cheese dressing is the best

Who likes blue cheese Survey
Everything and Anything
Replies 9 Post by jdurb1