Tractorpoint Login

print < Tractorpoint Login

Tractorpoint

Forums
- Search
- Forums
- New Posts
- Photos
- Manuals/Links
Parts
Support
Account

Search for =

Topic

Many thanks to all of you for your advice! :) Here's my plan:
1. Start tractor, let run for 15-20 minutes without using hyd. functions and feel for warm/hot components.
2. Run the tractor with bush hog until the problem occurs, then turn-off PTO and see if hydraulic function returns. Try shifting between Hi/Lo on transmission lever and see if hydraulic function changes.
3. Drain the hydraulic oil and remove filters, suction screen and filter relief valve. Clean suction screen and make sure relief valve can fully close. Reinstall valve and install new filters.
4. Replace the 3-pt. load shaft seals. Should I use standard JD replacement seals or is there a better after-market design available? Any special tools needed? How much shaft wear at the seals is acceptable?

Unfortunately, I may be a month or two before I get to this as I'm recovering from back surgery, but I will let you know how it works out. In the meantime, please let me know if anything else comes to mind.

Hydraulic Problem - John Deere 2750
John Deere Tractors
Replies 10 Post by KevinsJD