Go Bottom Go Bottom

noisy transmission

View my Photos
len-cr
Join Date: Apr 2016
Posts: 6
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2016-04-22          195010

have a LONG 2360 and the transmission sounds as if it is comming apart. The trans grouled when i bought it and dealer adjusted something and most of the growl went away. now it sounds as if a bearing is gone or something now that i am using it sounds as if all the gears are coming out of it . still does a good job but sure is noisy. any ideas? help. dont want to cause major damage

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



noisy transmission

View my Photos
Carolinablue
Join Date: Feb 2015
Posts: 28 NC
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2016-04-22          195012

I just replaced the release bearing in mine. Had been making some noise and the clutch was working just fine until all the bearing came out. Then it was doing the herky jerky.....Got her all fixed up now just as of yesterday. ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



noisy transmission

View my Photos
krb1945
Join Date: Oct 2013
Posts: 40 North FL & South GA
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2016-04-23          195016

len-cr,

my 2360 tranny is a little noisy and it only has 447 hours on it. I recently changed the hydraulic filter and oil thinking that may be the problem. It was still noisy after the change.

I found part of my noise problem was the pto engage / disengage lever was in the disengage position. I've read that can cause some major problems.

The second thing I found causing noise under the seat was the axle lock pedal was not releasing completely. I pulled it all the way up to the release by hand. I've got is washed down with pb-blaster, liquid wrench or wd-40 will work too. Then I lubed it with a spray white grease.

Those three things helped my noise but did not completely eliminate it. I suspect the spyder gears back under there get a wear pattern when the parts aren't releasing properly and that may be causing the noise.

If I find anything else causing the noise I'll post it... please do the same if you find something.

Also if your 3 pt lift is jumpy it may need a new hydraulic filter or your engine may be idling to low. I find mine gets jumpy when it engine idles to low or that filter starts getting clogged.

Good luck on finding the issue, KenB ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



noisy transmission

View my Photos
kthompson
Join Date: Oct 2005
Posts: 5275 South Carolina
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2016-04-23          195019

Of course the basic is check the fluid level and you probably have.

The post on wear pattern, been there and have a trans on a Kubota that growls for that reason. kt ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo


  Go Top Go Top

Share This
Share This







Member Login