Go Bottom

Mitsubishi Muffler shortage substitutes

View my Photos
runswithsizzers
Join Date: Jun 2007
Posts: 4 on the edge
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2007-06-28          143288


I have Satoh Beaver III, S-373D, made by Mitsubishi.

Due to the poor availability and high cost of Mitsubishi replacement mufflers, I have been considering having a generic muffler welded to the mounting plate of my present muffler. However, since I know nothing about muffler requirements for diesel engines, I wonder if it is necessary for the muffler to provide a certain amount of back pressure for the engine to run properly.

Has anyone tried substituting 3rd party mufflers on a diesel engine, and how did it work out?

Can anyone recommend a commonly available muffler for a 776 CC, 16 HP, 3 cylinder diesel engine?

Thanks,
-GW




Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



Mitsubishi Muffler shortage substitutes

View my Photos
earthwrks
Join Date: Dec 2003
Posts: 3853 Home Office in Flat Rock, Michigan
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2007-06-28          143315


I've had to improvise diesel mufflers for my equipment. I've used regular automotive mufflers from the local muffler shop. They tend to have a vast array of them that have many sizes and lengths and purposes, and "input" and "output" configurations--like having the "in" and outs" on the same end or opposite end or offset from each other. I'd try to stay with something with roughly the same in and out inside diameters. Otherwise, you might get a deep, throaty, overly-loud sound. With permission from the shop, I'd bring your tractor to the shop and just start experimenting with different sizes with it running. Then as a favor to the shop for their time and expertise, buy it from them and have them weld the flange and/or bemd pipe for you.

Keep in mind that if you don't replicate the mounting system (spring-held, supported vs. non, etc.) you could end up breaking the block or manifold.

If the muffler body itself is in decent shape (the inside baffles are not rattling inside) you might want to "rebuild" it with new sheet metal and a MIG or wire-fed welder. ....


Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo


   Go Top


Share This







Member Login