Go BottomBelarus 310 Starter Solenoid Wiring
 | JaimesBeam
Join Date: Feb 2013 Posts: 2 Maine 
|
2013-02-05 186150
I have a Belarus (Pray) 310 Tractor. I've been trying to rewire the
starter solenoid. The coil works fine, but the wiring to the coil is
all corroded.
When I tried to get the coil to throw the solenoid by hooking it up
the way I thought I should, I get nothing; that is connecting the
body/ground to negative battery, and the power connection to to
positive battary; nothing happens even when you short the starter switch/relay stud to positive..
If you take the cap that holds the electrical connectors off the
coil, you see that there are only two connections going into the
coil. One which goes to the starter relay/switch stud actually
has two wired connected together which go into the coil. The
other wire goes to the positive battery power.
The only connection I found to make the solenoid coil react is
connecting the two wires going into the coil to positive and
negative battery. Then the solenoid goes off!
This doesn't make any sense to me because the one wire goes
to the main battery positive power stud; the two wires that go
into the coil together go to the starter relay/switch!!!
Now I've paid to have this starter 'rebuilt' a couple of times;
it didn't seem like they were really doing anything because it
fail within a years again. So I decided to clean it up myself.
Maybe it's wiring is no longer original?
It doesn't help that you have to unsolder a couple of connections
just to get the cap off, and there's no way to put it back together
because the starter relay stud is soldered to a wire with no slack.
I put a ring terminal on the starter relay stud under the cap on a
wire a couple inches long to give me enough slack to push the
relay stud through the cap and then screw the cap on, and solder
the ring terminal outside the cap on the main power stud to the
wire that goes through the cap to the ring terminal.
Is it supposed to be like this? Has this already been screwed over
sometime in the past?
Thanks, Jaimes Beam
Reply to |
Quote Reply |
Add PhotoBelarus 310 Starter Solenoid Wiring
| nathanlann
Join Date: Aug 2012 Posts: 18 minnesota
|
2013-02-15 186199
Hello My name is Nathan Here is a few things to try WITH A TEST LIGHT TURN KEY TO START, YOU SHOULD HAVE FIRE ON LITTLE WIRE ON SOLENOID. IF NOT YOU HAVE BAD STARTING RELAY,BAD SWITCH OR BAD WIRE. IF YOU WANT TO ELIMINATE ALL PROBLEMS. GET A PUSH BUTTON STARTER SWITCH. RUN 2 WIRES TO STARTER PUT 1 WIRE ON LITTLE POST. PUT OTHER WIRE ON BIG POSITIVE POST COMING FROM BATTERY. IF TRACTOR DON'T START THIS WAY EITHER SOLENOID OR STARTER IS BAD.YOU CAN RUN ONE OF THE WIRES THROUGH THE NEUTRAL STARTING SWITCH SO TRACTOR WONT START IN GEAR. TO TEST SOLENOID OFF OF STARTER. TAKE JUMPER CABLES HOOK TO BATTERY PUT POSITIVE WIRE ON POST COMING FROM BATTERY PUT NEGATIVE WIRE ON OTHER BIG POST. TAKE JUMPER WIRE JUMP POSITIVE POST TO LITTLE POST. PLUNGER SHOULD SNAP IN,IF NOT SOLENOID IS BAD. If you have any other questions feel free to call, I also have Parts for your tractor if you need. 1(800)755-7938 ....
Reply to |
Quote Reply |
Add Photo
Go Top
Share This