Go Bottom Go Bottom

Craftsman Garden Tractor Mower Deck uneven after Blade change

View my Photos
bigcut
Join Date: Nov 2014
Posts: 3 SC Pennsyvania
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2014-11-16          191443

I have a craftsman 42" model 917.270820. Everything worked fine until I decided to change the blades. Put 2 ramps on the back of my tailgate, and elevated tractor and changed blades.
Since then, the right rear side of the deck is about an inch higher than the left rear side. Although, the front of deck is even side to side. Wha happened ??
How do I adjust or remedy without screwing up the front of the deck ???
Need Tractor Wizard to advise as to solution !!
Thanks,
John


Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



Craftsman Garden Tractor Mower Deck uneven after Blade change

View my Photos
kthompson
Join Date: Oct 2005
Posts: 5275 South Carolina
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2014-11-16          191444

Does it have a few links of chain in the lift system? If so could one of the links gotten in a bind and is locked up holding the deck up?
....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



Craftsman Garden Tractor Mower Deck uneven after Blade change

View my Photos
bigcut
Join Date: Nov 2014
Posts: 3 SC Pennsyvania
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2014-11-18          191456

Quote:
Originally Posted by kthompson | view 191444
Does it have a few links of chain in the lift system? If so could one of the links gotten in a bind and is locked up holding the deck up?


There is no chain whatsoever on the unit.
Thanks. ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



Craftsman Garden Tractor Mower Deck uneven after Blade change

View my Photos
yooperpete
Join Date: Jan 2004
Posts: 1413 Northern Michigan
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2014-11-18          191457

Some mower blades have a bend in them between the mounting surface and actual cutting blade. Are all the blades the same that were installed? Could one be mounting up side down? I've seen this happen lots of times. ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo


  Go Top Go Top

Share This
Share This







Member Login