Go Bottom Go Bottom

How do I get this part off the tractor so I can install a new one

View my Photos
videorov
Join Date: Oct 2006
Posts: 70 Bradenton,Fla
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2016-07-05          195438

I can't seem to figure out how to take this cover plate off
so I can install a new one. The old one is worn around the hole of it.
I have all the bolts out but it does not seem to move.
Anyone have pictures of taking one of these off?????


Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



How do I get this part off the tractor so I can install a new one

View my Photos
videorov
Join Date: Oct 2006
Posts: 70 Bradenton,Fla
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2016-07-05          195439

....

Picture Link
Belarus How do I get this part off the tractor so I can install a new one
Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



How do I get this part off the tractor so I can install a new one

View my Photos
kthompson
Join Date: Oct 2005
Posts: 5275 South Carolina
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2016-07-07          195442

Look at the shaft that runs through it to see if it is worn to where there is a groove in it that is holding the plate on. It also could be they used a liquid of even gasket that has just stuck holding the plate on. Would suggest you take hammer (would be careful if you use steel hammer) that you tap around the bolt pattern to see about breaking the seal, if that is the issue. ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



How do I get this part off the tractor so I can install a new one

View my Photos
videorov
Join Date: Oct 2006
Posts: 70 Bradenton,Fla
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2016-07-07          195443

Quote:
Originally Posted by kthompson | view 195442
Look at the shaft that runs through it to see if it is worn to where there is a groove in it that is holding the plate on. It also could be they used a liquid of even gasket that has just stuck holding the plate on. Would suggest you take hammer (would be careful if you use steel hammer) that you tap around the bolt pattern to see about breaking the seal, if that is the issue.


Yes I have the whole left side off of the old gear system
and brake housing. I has a new used whole system including the shaft that will go back on. But I noticed the collar had wear on the hole and the rubber garment was shot too. So going to replace them both before I put back the whole new left side gear system. ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



How do I get this part off the tractor so I can install a new one

View my Photos
videorov
Join Date: Oct 2006
Posts: 70 Bradenton,Fla
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2016-07-07          195444

....

Picture Link
Belarus How do I get this part off the tractor so I can install a new one
Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



How do I get this part off the tractor so I can install a new one

View my Photos
videorov
Join Date: Oct 2006
Posts: 70 Bradenton,Fla
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2016-07-07          195445

....

Picture Link
Belarus How do I get this part off the tractor so I can install a new one
Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



How do I get this part off the tractor so I can install a new one

View my Photos
videorov
Join Date: Oct 2006
Posts: 70 Bradenton,Fla
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2016-07-07          195446

Im going to pull the old shaft out too after I get the collar off.
The two bolts with the metal strap is just sitting there and I have
them off too. They must have put some type of gasket glue behind the collar and its holing it on. ....

Picture Link
Belarus How do I get this part off the tractor so I can install a new one
Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



How do I get this part off the tractor so I can install a new one

View my Photos
videorov
Join Date: Oct 2006
Posts: 70 Bradenton,Fla
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2016-07-07          195447

New part I will be installing once I get that collar off and replaced plus the rubber gromet that goes into the hole of the collar where the shaft will
go into when I put the new one on. ....

Picture Link
Belarus How do I get this part off the tractor so I can install a new one
Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



How do I get this part off the tractor so I can install a new one

View my Photos
videorov
Join Date: Oct 2006
Posts: 70 Bradenton,Fla
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2016-07-08          195448

Well I got it OFF and used a flat chisel got to move a little then it came off. Yes it had a fiber gasket with some glue on it. ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



How do I get this part off the tractor so I can install a new one

View my Photos
videorov
Join Date: Oct 2006
Posts: 70 Bradenton,Fla
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2016-07-08          195449

....

Picture Link
Belarus How do I get this part off the tractor so I can install a new one
Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



How do I get this part off the tractor so I can install a new one

View my Photos
videorov
Join Date: Oct 2006
Posts: 70 Bradenton,Fla
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2016-07-08          195450

This is what is behind it and now I can buy a new one plus a new oil seal for it and pull the rest of the broken shaft out. One guy had told me to be sure and engage the positive tracktion lever too so when I put the new shaft in with the reduction assembly nothing will be in my way.

One thing at a time.:) ....

Picture Link
Belarus How do I get this part off the tractor so I can install a new one
Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo


  Go Top Go Top

Share This
Share This







Member Login