Hi, the pin at top end of my 3 point arm slipped out a bit and i ended up bending one side of the u shaped holding arm (while i was using the roto vator)
the holes now do not line up so the pin will not go back into the far hole
a thinner pin will just get through - does anyone think it will be strong enough to last?
I doubt it. Makes more sense to straighten the u-connector. Why not just take it to a machine shop and let them realign the holes in a hydraulic press?
I noticed that you have this question in two places. Seeing as how your profile says you have a MF, I think that is the more appropriate place. I'm moving my respone over there.
3 point arm is bent: John Deere Price -- John Deere Tractors Discussion Forum
10-24-2009, 22:19 
Digg It 
Del.icio.us 
Technorati 
Furl 
Stumble This 
Pics
