Go Bottom

1988 Belarus 562 release bearing lube point advice on getting clutch

View my Photos
1988562
Join Date: Nov 2010
Posts: 2 VA
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2010-11-18          175230


I have a 88 model 562 that the clutch has stopped working on, it was parked for a while and now the clutch wont release at all. It was working normally with no slips or problems when it was put up.

I had wondered if the clutch plate had rusted to the flywheel but can't figure out how to bust it loose.

My manual says to lube the release bearing but I can't find the lube point, or fitting to grease.

This is my first tractor, and I'm still learning about how everything works on it.

Any advice appreciated and a pic of where the release bearing lube fitting would be worth a ton.




Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



1988 Belarus 562 release bearing lube point advice on getting clutch

View my Photos
tnpines
Join Date: Jul 2011
Posts: 2 west tn
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2011-07-09          179329


if it is like my 525 left side on bellhousing is a square plug that has to be removed then insert grease gun thru hole and onto lube fitting - give it only about 2 pumps from gun -- not likely to free it up though - have another tractor pull you on this tractor with it in a higher gear and work clutch pedal in and out -- make sure fuel is turned off so tractor will not start -- this may free up clutch ....


Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



1988 Belarus 562 release bearing lube point advice on getting clutch

View my Photos
jakeflyer
Join Date: Sep 2010
Posts: 29 Dallas
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2011-07-19          179460


I have a 572 that had the problem. call me if you wnat to. 714.331.5135 ....


Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo


   Go Top


Share This







Member Login