250 oil leak pushrod tubes
belarus250
Join Date: May 2008 Posts: 30 NE |
2008-05-14 153698
Can someone tell me how to replace the seals at each end of the tubes that contain the pushrods. I have a bad leak at the top and bottom of one pushrod tube on the rear cylinder. For some unknow reason the last person in put hose clamps on each end of the tubes in an attempt to perhaps hold the tubes up against the seals? The worst leak is the upper seal.
Sure would like to know how much I have to take apart to replace them. I hope it's just the rocker cover, rocker shaft and rockers and not the whole head on that cylinder.
The seals look brittle, I guess the heat beats them up good.
Thanks in advance for any help with this.
Ken
Reply to | Quote Reply | Add Photo
250 oil leak pushrod tubes
vladimirec
Join Date: Mar 2009 Posts: 29 Croatia |
2009-03-10 160938
You have to remove head, after that it's simple. take out the tube and replace o-rings. ....
Reply to | Quote Reply | Add Photo
Go Top
Share This